![]() ![]() In this instructable I will show how to layout the pattern to cut a pipe for a saddle cut. ![]() Well, I didn't remember the formula right off, but I did remember how to figure it out without a formula. He knew there had to be a mathematical formula to do it and knew I might know where to find it. The resulting pattern will look like the profile of a saddle, a curved center section that goes over the second pipe and two curved sections that extend down on either side.ĭad's project had a smaller HDPE pipe that would be used as a form to pour concrete around an orchard valve over the larger cement supply pipe. A saddle cut is a way of cutting one pipe to match the outside curved surface of another pipe. This last summer I was contacted my father who needed to layout the pattern for a saddle cut for an irrigation system he was installing. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |